| ВТУЛКА РОТОРА |
| This
head was built from original drawings of the Bensen B8 Offset Gimbal head,
I have added bearings and trunnions to the lateral and longditudal forks
in a similar style to the teeter forks, rather than have the bolts bearing
directly onto the aluminium. This involved some changes to the shape of both sets of forks but still retaining the key dimensions of the Bensen head. Making the head is not a difficult task if you have the machines and skill to use them, but it is time consuming because each set-up is only for one or two components, it would be true to say that you will spend far more time setting than machining and scrapping a part will add even more set-up time. Add to this the problems of getting the correct materials in small quantities at reasonable cost and you can see that unless you enjoy working your machines, building a head makes no sense ,IT IS FAR MORE COST EFFECTIVE TO BUY A COMMERCIALLY BUILT ITEM. But if you still fancy hours of frustration and turning good metal
into swarf, drawings for the ORIGINAL Bensen B8 Offset Gimbal Head can be
downloaded from the Drawings page,they are in a ZIP file in AWD format and
can be viewed in IMAGING. Drawings of the modifications I have made
can be seen HERE.
|
 |
Втулка в сборе. Обратите внимание: продольный рычаг не имеет отверстий, но это не принципиально, т.к. отверстия служат только для снижения веса рычага. Это снижение веса может быт достигнуто и другими способами, например, продольной выборкой по бокам рычага (на некоторых фотографиях на диске это показано) |
 |
Этот
плохой
снимок
показывает: (a) То, что автор не умеет обращаться с простейшим фотоаппаратом (b) Втулки горизонтального болта (c) Верхние щеки (c) Блок коромысла Отверстие в центре блока - центрирующее, для облегчения сборки и центровки коромысла |
